close
fastener solutions at the concept of your design
enter a part no. or keyword then press go
Request a sample
Sign up to our Monthly Newsletter...
Company Name:
Name:
Email Address:
Got a question
or an enquiry?
Click here and our friendly staff
will be happy to assist you.
Click here for a PDF
version of this page.
All information is given for guidance only
and designers should satisfy themselves as to
the suitability of the specification
by requesting samples

Pressin* Hardened Press in Inserts

Click Here for larger image
Series 20117 Type : HPI
Pressin* Hardened Press in Inserts
close
Part No. Thread MDim BDim CDim L (Max)Rec. Hole size  
Part No. Thread MDim BDim CDim L (Max)Rec. Hole size  
 HPI030H045M35.34.84.54.8request sample 
 HPI040H069M47.77.16.97.2request sample 
 HPI050H069M57.77.16.97.2request sample 
 HPI060H095M610.39.59.59.6request sample 
Series 20117 Type HPI Inserts and Studs, offer very hard wearing threads in lighter alloys, preventing the stripping of threads where multiple installation / removal of the mating screw is likely. They are also suitable as an effective remedy for the reclamation of stripped threads. There is no requirement for pre- tapped holes. They are fast to install and no special tooling is required for assembly. A simple press assembly with a polished flat punch is all that is required. A smooth hardened punch is advisable when installing these inserts to minimise friction and thus to allow the insert to rotate freely during installation. To achieve optimum pull-out loads the design must be such that a stationary component is always in contact with the top of the peripheral edge of the insert. This guarantees pull-out of the insert will only occur by total shear of the parent material.
Request information about:
Series: 20117 Type: HPI Pressin* Hardened Press in Inserts
Your Question
/Enquiry:
Your
email address